Follow these simple steps to assemble this amazing bed. Parts List: Step 1: Attach the long rail (04) to headboard (02) and footboard (03) as shown below. Using JCB (A)...
parts and hardware
2. Fit Side Panels & Support onto Drawer Face.
Lay the Drawer Front on a smooth, flat surface so the holes and groove are facing upwards. Fit the Side Panels to the Drawer Front, fitting the dowels in the holes. Use two 16mm Bolts to attach the Side Panel in place, but don’t fully tighten these yet. Leave them a bit loose, to make fitting the Back Panel easier.
Fit the Support into dowel holes provided on the Drawer Front.
3. Fit Drawer Bottom
Guide the Drawer Bottom in carefully so that it won’t jump out of its grooves. Be sure it fits fully into its groove at the bottom (in the Drawer Front,) before fitting the Back Panel.
4. Fit Back Panel
You will need to spread the Side Panels apart a bit to fit the dowels in the Back Panel into their holes. Do this gently, please! Remember, the Bolts in Step 2 must be a bit loose. After this, tighten all the Bolts on the Drawer Front.
- Be sure the holes are free of wood chips and saw dust.
- Insert Barrel nuts as shown using a screwdriver. This will help you position the Nut in line with the Bolt.
- Do not force the Bolt as you may strip the thread. Be sure the thread is properly started.