Ginger Full Bunk Bed Assembly Instructions


SIZE OF MATTRESS AND FOUNDATION:
Use only mattress, which is 53″ – 54″ width and 74″-75″ long on upper bunk (full size.)
Ensure that the thickness of the mattress does not exceed 6″ and that the mattress surface is at
least 5″ (127mm) below upper edge of guardrails.
WARNING:
Adult Assembly Required. This package contains small parts. Keep away from children.


Parts and Hardware

Parts and Hardware


Assembly Instructions

2A. Fit Wood Dowels to the Stretchers.
2B. Fit Wood Dowel to the Middle Rail.
PAssembly Instructions

2C. Attach Stretchers and the Lower Middle Rail to the Lower Bunks.

PAssembly Instructions
Bolt and Barrel Nut Assembly.
Do not force the Bolt as you may strip the thread. Be sure the thread is properly started.
Be sure the holes are free of wood chips and saw dust.

3A. Fit the Slats between the Stretchers.
Lay the Slats inside the Stretchers as shown below, and Bolts in place with 40mm threaded Wood Bolts (total 4 Bolts)

3.B Fix the Remaining Slats with screws.
PAssembly Instructions

4.A Fit Wood Dowels to the Upper Middle Rail.
4.B Attach Stretchers, Upper Middle Rail and Rear Guard Rail to the Upper Bunk.
PAssembly Instructions
Bolt and Barrel Nut Assembly.
Do not force the Bolt as you may strip the thread. Be sure the thread is properly started.
Be sure the holes are free of wood chips and saw dust.

5A. Attach the Front Guard Rail to the Upper Bunk.
Tap Wooden Dowels into the ends of the Front Guard Rail. Use the 90mm Bolt and Barrel Nut fix it in place. The Front Guard Rail attaches to the Upper Stretcher using the 30mm Bolts.
PAssembly Instructions

6.A Bolt the Slats to the Stretchers.
Lay the Slats inside the Stretchers as shown below, and Bolt in place with the 40mm Threaded Wood Bolts
(total 4 Bolts.)
6.B Fix the Remaining 6B Slats with screws.
Use the wood screws to fix the remaining slats to the Stretchers (total 18 screws.) An electric screwdriver will make this much easier.
PAssembly Instructions

7.A Fit the Upper Bunk onto the Lower Bunk.
Fit the Metal Tubes into the holes on the top of the Upper Bunk. Carefully Lift the Top Bunk onto the Lower
Bunk.
7.B Fit the Brackets to the Legs
Use the 60mm Bolts to fix the Brackets to the Lower Bunk.
PAssembly Instructions

8.A Attach the Ladder to the Upper Stretcher.
Finally, hook on the Ladder onto the Upper Stretcher. Use the 16mm Wood Screws to fix the Ladder in place.
Please take note of the warnings shown on page one of these instructions, printed on the carton box and on stickers on the Bunk bed.
PAssembly Instructions

Leave a Reply

Your email address will not be published. Required fields are marked *