Rosebud Daybed Assembly Instructions

Hardware

Assembly Instructions

1. Fit Bolts loosely to Arms.
Insert the 20mm Bolts into the bottom two holes on the Arms. Screw in about five turns only.

2. Fix the Rails to the Daybed Arms.
Note: Dont fully tighthen the Bolts until the whole frame is put together.

3. Fit the Slats between the Rails.
Lay the slats out between the Rails. The end slats of each set is fixed with the 40mm Bolts.

4. Fix the Back Panel in place with the 60mm Bolts.
Remember that the Bolts on the Arm should be LOOSE.

Leave a Reply

Your email address will not be published. Required fields are marked *